Despite the ongoing interest in
automation, manual spraying is still
the most used and remains a very
effective method for applying
Simalfa. Providing the system is
installed correctly, spray guns are
set properly, and operators use
proven techniques, clients can
benefit greatly.
Here are some tips to optimize the
manual spraying of Simalfa.
Helpful Documents
Simalfa TIPS -
Better Manual Spraying
Simalfa TIPS - Understanding
Overspray
Simalfa TIPS - Understanding Tack
vs. Cure
|
Installation + Maintenance |
Install an air regulator for each
spray gun.
Install air regulators out of the
sprayers' / users' reach.
Replace damaged parts of the spray
gun.
Inspect air hoses and air
connections regularly. A 1/4" air
leak can cost thousands per year in
electricity alone.
Clean and maintain the spray gun
according to the manufacturers'
recommendations.
Minimize fluid volume coming from
the spray gun.
Control atomization air pressure
in relation to adhesive volume.
Match the spray gun
and settings (nozzle, needle,
air cap) with the
adhesive. Failure to choose the
correct equipment generally
results in lower efficiencies
and increased adhesive costs
through waste and overspray.
Increase spray gun transfer
efficiency or product yield by
implementing more consistent spraying
techniques.
Maintain the proper spraying
distance and angle from the substrate.
Download the Helpful
Documents above and post in the
spray area for reference.
